As a student, the economy is often quite a challenge and refurbishment of a lease can run into thousands of kroner.
But you can easily save huge amounts by rolling up our sleeves and even perform the work.
Here we look at sanding of the floors and painting.

There are several advantages to hone his floor itself. One of them is that it is much smarter financially, while profit can be as good as it was done by a professional. It requires that you have the proper equipment and made a good preparation. In this guide we will help you to explain how you sand your floor and you have to be aware of.

The good preparation

A good preparation is half the work. Therefore, we recommend that you use the time to prepare the whole space to be sharpened. Therefore, all furniture, carpets and the like are removed. In addition, the floor must be vacuumed, so small things do not come in the way of sanding. Final make sure that you have the necessary equipment. You must have a gulvafsliber in good condition as well as edge and corner sander.

Know the technical terms

When you need to start grinding, it is wise that you have a knowledge of concepts such. cereal. Grain is what you use to grind the floor, and it must be done in a proper order to give the best result. The coarser the grain, the lower the figure. Therefore, you should start with a low grain that could be grain 18 or 24 and conclude by higher and finer grain. You must cut three times and gradually increase the grain number each time. You can not skip a grinding through, and if you do it in the wrong order, the result is bad.
You may read more "step-by-step" guide to floor sanding here

During the grinding

When sharpening, it is important that you give yourself plenty of time to get sanded thoroughly. If you hurry across the floor, it will be characterized by inattentive grinding. Take your time and try to move quietly forward. It is therefor important that you ensure that your machine is set to cereals, now you want to grind with. You should have permanent machine in motion to avoid the start and burn marks.

Corners and edges

Corners and edges must be sanded individually. The principle is the same as that of the remainder of the floor. You start with a low grain and move quietly up. The difference is that the corners and edges can not grind with the normal machine. Here you can use a corner grinder for corners and an edge sander to the edges. Therefore, make sure that you have such some available. Otherwise, you can not grind the floor finished, and it would be a shame.

Mistakes will happen

Is this the first time you go to war with a floor sanding, there will be errors. But do not turn out. If you've had the machine in motion during grinding, the errors will be less than 1mm deep. They must be repaired by grinding again around the area. The only thing it will affect is the wear layer, and you can not do anything about. Are there deeper marks, can be repaired with a wooden spatula. The worst thing you can do is panic. Then errors that are harder to repair, arise.

Withdraw all knowledge to you

You can get very far with common sense and good preparation. Therefore, you may want to absorb knowledge you before the actual grinding. Search the Web if you have doubts, or consult professionals for advice. There are many who are ready to help you, and there are both good guide and tips on the internet for example. on Davids-gulvafslibning.dk overflowing with free tips and advice. If you are well prepared, it can not go wrong, and should an accident occurs, you should proceed calmly. If you do not have the courage task yourself, there are many professional people who are ready to grind your floor.